To enter programming mode on the Responder Remote:

Press and hold the black Program button on the back of the remote or hold the four remote control buttons on the front of the remote simultaneously (Only if you do not have the program button on the back of the remote) until one long beep is heard. Programming Mode has now been entered.

To change different vehicles (Viper 5000, Python 900 and Clifford 10.5X only):

Simply press the black Program button on the back of the remote once quickly to
cycle thru numbered vehicles 1 thru 4.

Page Notification:

The remote control can be programmed to notify the user of a page by audibly beeping or remote vibration.

Beep Mode:

Beep Mode includes alarm arm/disarm diagnostic beeps and
distinctive two-tone remote start beeps.

Vibrate Mode:

Vibrate Mode makes page notification silent but does not include
diagnostic information or distinctive remote start notification.

Illumination:

Illumination for the LCD display can be programmed on or off. When programmed on the LCD will illuminate every time the remote control receives a page or transmits a command. Programming illumination on will decrease the life expectancy of the battery.

Beep/Vibrate Mode:
Within five seconds of entering Programming Mode, press The remote control will beep once for on, twice for off. (Three times for both beep and vibrate, Four times for no beep and vibrate on
the Viper 5000, Python 900 and Clifford 10.5X only) vibrate icon will also turn on/off with each press.

Illumination On/Off:
Within five seconds of entering Programming Mode, press The remote will beep once for on, twice for off and the light will turn on/off with each press.

Page Mode On/Off:
After entering Programming Mode, press within five seconds to toggle on and off. When the Page Mode is on, the remote control will wake up periodically to check for messages from the security module. It will also wake up when any button is pushed. When Page Mode is off, the remote control “sleeps” until a button is pushed, extending the life of the battery. Press the instead for the Viper 5000, Python 900 and Clifford 10.5X only.

To Exit Programming Mode

To exit Programming Mode, take no action for five seconds. The remote control will generate two beeps to indicate programming mode has been exited.