Model 600d Class D Mono Amplifier

FEATURES:

Super-efficient Class D PWM design
Runs much cooler than conventional amp designs.
High speed MOSFET switching power supply.
High current complimentary MOSFET outputs stable into 1 ohm loads.
Thermal, DC offset, reverse polarity and short circuit protection with status LED.
Master/slave RCA jack functions support two amps bridged to one load.
Continuously variable 18 dB/octave low-pass crossover.
Switchable continuously variable 18 dB/octave subsonic filter.
Switchable 8 dB bass eq function.
Switchable phase invert function.
Remote subwoofer level control supplied.
Variable input sensitivity optimizes match with different signal sources.
Gold-plated wire terminals and RCA connectors ensure maximum signal transfer.
Rugged one-piece extruded heat sink with insulated nylon mounting feet.

SPECIFICATIONS:

275 watts RMS into 4 ohm, < 0.4% THD @14.4VDC

400 watts RMS into 2 ohm, < 0.6% THD @14.4VDC

600 watts RMS into 1 ohm, < 0.8% THD @14.4VDC

Dynamic Power Rating (minimum load/14.4VDC)
750 watts

Conversion efficiency (4 ohm operation)
Greater than 80%

Signal-to-Noise Ratio
Greater than 80 dB

Frequency response
20-250 Hz +0, -1 dB

Typical Damping Factor
50

Crossover range
30 to 250 Hz

Subsonic filter range
20 to 50 Hz

Input Impedance
20 kohm

Input Sensitivity
variable from 150mV to 8 volts

Output Impedance
stable to 1 ohm

Supply Voltage
9 to 16 VDC

Heat Sink Dimensions (H x W x L)
2" x 8-3/4" x 9-13/16"