HOME > Remotes > 465T & 493T Remote Programming Instructions

465T & 493T REMOTE PROGRAMMING INSTRUCTIONS

The 465T and the 493T requires 2 steps for successful programming of your existing DEI alarm, remote start
or keyless entry. Below shows all the necessary tools and programs needed. Step 1  Step 2

465T & 493T White Sticker Program Number Examples

Click Here for Larger Image Click Here for Larger Image Click Here for Larger Image
Click Here for Larger Image Click Here for Larger Image Click Here for Larger Image
Click Here for Larger Image Click Here for Larger Image Click Here for Larger Image
Click Here for Larger Image Click Here for Larger Image Click Here for Larger Image

 

Step 1

Look for a white sticker on the inside of an existing remote or the outside and/or inside
of the main alarm/keyless entry brain. On the 460 & 465T, An Example would be: 209AD or 1AF2D, This is your programming code. On the 493T, An Example would be 322431A (It may or may not
have an "A" at the end). This is your programming code. Once you have located your Code numbers, you can determine the correct traces to be cut on your new replacement remote below:

Download TX Code for faster programming of these remote.
Or download TX Code and select "Open" from the prompt. If your computer requires the vb40032.dll software in order to run TX Code, then download this dll file and place in your windows directory path under C:\windows\system and the program should run properly.
 

Step 2

Take the new remote apart with a small Phillips screwdriver and pry open the remote case carefully.
Next, remove the battery and gently pull outwards on the circuit board to pop out the circuit board
guts. Flip the circuit board over to reveal the trace numbers with either a group of five set of numbers
ranging from 1, 2, 5, 6 or 2 rows of numbers ranging from 1 thru 12. After you have determine the
correct traces to be cut, grab either a small, sharp flat tip Jewelers screw driver or a Dremel tool
with a small cutter bit and carefully notch out each number trace as required by Step 1. Once done,
double check your circuit board traces and assemble the remote back together and try on your
alarm, remote starter or keyless system. If un-successful, take the remote apart again and recheck
all the traces to insure that each cut has been completely interrupted. If un-sure on programming
this remote, try locating a local electronics store or DEI Dealer for further help.

Please Call: 513-574-7879 Or Toll Free: 1-855-574-7879
E-Mail Us At: Dr.Detail   /  Or Ask A Question Here
Open Monday-Saturday 10:00 Am till 6:00 Pm EST

 
Copyright 2001-2014 [Dr.Detail]. All rights reserved.

Back to Top